1
Truss elements in compression displaying zero force
Details of the bug
When truss elements are in compression, the force in the truss element was still zero, or near zero, and therefore the displayed results for those elements is incorrectly shown as zero, or near zero. This affects the displayed and reported axial forces for compression truss elements only. Truss elements in tension are not affected.
Affected versions
Version 14.50.155 only, released on 27 July 2026. No earlier versions were affected.
Remedy
Fixed in version 14.50.159
The problem is fixed in version 14.50.159 and all later versions, released from 12 August 2026 onwards. If you have one of the affected versions then we strongly advise you to upgrade to the latest version.
2
Non-linear materials — Von Mises stress max and plastic strain contours displaying incorrect values
Details of the bug
When a non-linear analysis with non-linear materials is run for multiple load cases, the contour results were unintentionally accumulating between load case runs, resulting in incorrect values being displayed. This affects the Von Mises stress max and plastic strain contours only. All other contour types are unaffected and display correct values.
Affected versions
Version 14.50.155 only, released on 27 July 2026. No earlier versions were affected.
Remedy
Fixed in version 14.50.159
The problem is fixed in version 14.50.159 and all later versions, released from 12 August 2026 onwards. If you have one of the affected versions then we strongly advise you to upgrade to the latest version.
